Applicant must be time served on a CNC Horizontal Borer background, ideally in a sub-contract environment. CNC Controls are Giddings & Lewis 8000b or KTM Modular D or Siemens 840C the applicant (ideally) would have experience of these controls. The machine (is yet to be confirmed) but the operator would be expected to MDI small programs for skimming reference setting faces, clamping grooves or boring out fixture locations etc. Programs and routings are given to the operator and it his/her responsibility to load the program, setup the machine and all the tooling designated in the program, including fixtures, pre setting & configuring of all spindle tooling, boring bars, load the tool changer and other associated equipment. Perform block by block line by line prove out of the program in accordance with routing and quality plan instructions. When the operation is complete it is the operator's responsibility to carry out inspection both in process of the prove out function and at completion of the operation before submission to inspection. The operator may need to edit and optimise the program and to observe and correct any errors in the program, or report to supervision if too complex (rare). The operator would need to be well versed in ISO (metric units) and Imperial (English) measurement as both disciplines are commonplace. Technical drawings again are in both disciplines. The operator would also need to be well versed in all types of measuring instruments, micrometers, venires, dial test indicators, bore comparators and be able to set and measure with these instruments. Safety and setups on these machines is of prime importance, clamping knowledge and safe setting is of absolute importance as work pieces can weigh up to 2 tons or more. Our client machine many types of threads, of both parallel and taper variants with many differing thread forms, any operator must be able to both machine and gauge these elements.